Dirt Bike Throttle Cable Sticking

But within 2 7 seconds ish of riding it i could tell that the throttle needed some attention.

Dirt bike throttle cable sticking.

Additionally the throttle cable just through general wear and tear stretches breaks or thanks to the dirt build up gets sticky too. Although it would eventually. Inspect the throttle cable that it s routed properly and doesn t get pinched by the handlebars turning motion and not intertwined with the brake or clutch cables and electric start cable if applicable. If the screws in the throttle housing are too tight it could cause the cable to stick.

If you are suspecting problems with a dirt bikes throttle body operation it s recommended that you check to be sure the throttle cables are not binding or crossed anywhere and causing a slow return of the throttle when released as short of this there is not much else that could cause a binding or sticking throttle as far as the throttle body. Little else terrifies a rider on a dirt bike when that pin gets stuck. Not only was the dirt bike throttle sticking it was not snapping back and it seemed like the throttle wouldn t return. A stretched throttle cable won t give your bike much life and obviously a broken cable doesn t work but a sticky cable or throttle tube can produce these kinds of results.

Drained it out and bike was good to go. Lube the throttle cable regularly which prevents it from getting. Pretty darn cool bike actually. A few weeks ago i dropped my bike in a creek and sucked in quite a bit of water.

The cables can bind under the tank or in the handgrip. Next ride the throttle kept sticking open when i was riding so i decided to replace the throttle cable since it was getting a little frayed. Or it can be caused by an issue with the carburetor or efi.